skip to content
Dovepress - Open Access to Scientific and Medical Research
View our mobile site

8852

Preparation, characterization and relative bioavailability of oral elemene o/w microemulsion

Original Research

(2265) Views  (782) Full article downloads

Authors: Zhaowu Zeng, Guanglin Zhou, Xiaoli Wang, et al

Published Date August 2010 Volume 2010:5 Pages 567 - 572
DOI: http://dx.doi.org/10.2147/IJN.S12485

Zhaowu Zeng1, Guanglin Zhou1, Xiaoli Wang2, Eric Zhijian Huang1, Xiaori Zhan1, Jun Liu1, Shuling Wang1, Anming Wang1, Haifeng Li1, Xiaolin Pei1, Tian Xie1

1Research Center for Biomedicine and Health, Hangzhou Normal University, Hangzhou, Zhejiang, China; 2Yichun University of Jiangxi Province, Yichun, Jiangxi, China

Abstract: The objective was to develop an elemene oil/water (o/w) microemulsion and evaluate its characteristics and oral relative bioavailability in rats. Elemene was used as the oil phase and drug, polysorbate 80 as a surfactant along with ethanol, propylene glycol, and glycerol as the cosurfactants. The microemulsion was prepared by mixing method, or ultrasonication method in an ultrasonic bath. Its three-dimensional response surface diagram was drawn by Mathcad software. The microemulsion was characterized by visual observation, cross-polarized microscopy, size, zeta potential, acidity, viscosity, and surface tension measurement. The drug content and entrapment efficiency were determined by ultra fast liquid chromatography (UFLC) and liquid surface method. Blood was drawn from rats at different time points after oral administration of an elemene microemulsion or a commercial elemene emulsion for measurement of the drug in plasma by UFLC to establish the pharmacokinetic parameters and relative bioavailability. The elemene microemulsion as a clarified and isotropic system containing 1% elemene (w/v), 5% ethanol (v/v), 15% propylene glycol (v/v), 15% glycerol (v/v), and 5% polysorbate 80 (w/v), was characterized as (57.7 ± 2.8) nm in size, 0.485 ± 0.032 in polydispersity index, (3.2 ± 0.4) mv in zeta potential, (5.19 ± 0.08) in pH, 6 mpa•s in viscosity, (31.8 ± 0.3) mN•m-1 in surface tension, (8.273 ± 0.018) mg•mL-1 in content of ß-elemene, and (99.81 ± 0.24)% in average entrapment efficiency. The area under the concentration-time curves from 0 h to 24 h (AUC0→24h) of the elemene microemulsion and commercial elemene emulsion were integrated to be 3.092 mg•h•L-1 and 1.896 mg•h•L-1 respectively, yielding a relative bioavailability of 163.1%. The present study demonstrates the elemene microemulsion as a new formulation with ease of preparation, high entrapment efficiency, excellent clarity, good stability, and improved bioavailability.

Keywords: elemene, microemulsion, relative bioavailability





 

Other articles by Dr Zhaowu Zeng



Readers of this article also read:

Evidence-based decision-making within the context of globalization: A “Why–What–How” for leaders and managers of health care organizations
Radiolucency below the crown of mandibular horizontal incompletely impacted third molars and acute inflammation in men with diabetes
Exacerbation rate, health status and mortality in COPD – a review of potential interventions
Effects of chitosan coating on physical properties and pharmacokinetic behavior of mitoxantrone liposomes
Progress in antiretroviral drug delivery using nanotechnology
Preparation and characterization of solid lipid nanoparticles containing cyclosporine by the emulsification-diffusion method
Development of biodegradable polymer based tamoxifen citrate loaded nanoparticles and effect of some manufacturing process parameters on them: a physicochemical and in-vitro evaluation
Amino acid management of Parkinson’s disease: a case study
Comparison of two treatments for coxarthrosis: local hyperthermia versus radio electric asymmetrical brain stimulation
Radio electric asymmetric brain stimulation in the treatment of behavioral and psychiatric symptoms in Alzheimer disease