skip to content
Dovepress - Open Access to Scientific and Medical Research
View our mobile site

8852

Fabrication and characterization of graphene hydrogel via hydrothermal approach as a scaffold for preliminary study of cell growth

Original Research

(1683) Views  (934) Full article downloads

Authors: Lim HN, Huang NM, Lim SS, Harrison I, Chia CH

Published Date August 2011 Volume 2011:6 Pages 1817 - 1823
DOI: http://dx.doi.org/10.2147/IJN.S23392

HN Lim1, NM Huang2, SS Lim3, I Harrison3, CH Chia4
1Centre for Ionics University of Malaya, Physics Department, Faculty of Science, University of Malaya, Kuala Lumpur, 2Low Dimensional Materials Research Centre, Physics Department, Faculty of Science, University of Malaya, Kuala Lumpur, 3School of Chemical and Environmental Engineering, Faculty of Engineering, The University of Nottingham Malaysia Campus, Jalan Broga, Semenyih, Selangor, 4School of Applied Physics, Faculty of Science and Technology, Universiti Kebangsaan Malaysia, Selangor, Malaysia

Background: Three-dimensional assembly of graphene hydrogel is rapidly attracting the interest of researchers because of its wide range of applications in energy storage, electronics, electrochemistry, and waste water treatment. Information on the use of graphene hydrogel for biological purposes is lacking, so we conducted a preliminary study to determine the suitability of graphene hydrogel as a substrate for cell growth, which could potentially be used as building blocks for biomolecules and tissue engineering applications.
Methods: A three-dimensional structure of graphene hydrogel was prepared via a simple hydrothermal method using two-dimensional large-area graphene oxide nanosheets as a precursor.
Results: The concentration and lateral size of the graphene oxide nanosheets influenced the structure of the hydrogel. With larger-area graphene oxide nanosheets, the graphene hydrogel could be formed at a lower concentration. X-ray diffraction patterns revealed that the oxide functional groups on the graphene oxide nanosheets were reduced after hydrothermal treatment. The three-dimensional graphene hydrogel matrix was used as a scaffold for proliferation of a MG63 cell line.
Conclusion: Guided filopodia protrusions of MG63 on the hydrogel were observed on the third day of cell culture, demonstrating compatibility of the graphene hydrogel structure for bioapplications.

Keywords: cell culture, graphene, hydrogel

 








Readers of this article also read:

Nanofibers and their applications in tissue engineering
Evidence-based decision-making within the context of globalization: A “Why–What–How” for leaders and managers of health care organizations
Radiolucency below the crown of mandibular horizontal incompletely impacted third molars and acute inflammation in men with diabetes
Morgellons disease: Analysis of a population with clinically confirmed microscopic subcutaneous fibers of unknown etiology
Amino acid management of Parkinson’s disease: a case study
Solvent effects on structural and thermochemical properties of p53 tumor-suppressor gene: a molecular modeling approach in drug design
Quantum dot-based quantitative immunofluorescence detection and spectrum analysis of epidermal growth factor receptor in breast cancer tissue arrays
Reduction of atherosclerotic lesions in rabbits treated with etoposide associated with cholesterol-rich nanoemulsions
Erratum
Simple room-temperature preparation of high-yield large-area graphene oxide